Measuring saddle length

laceyfreckle

Well-Known Member
May 27, 2007
9,685
42
48
Essex/Suffolk
Can I just check that I'm measuring correctly?

I recently bought a saddle off ebay, a thorowgood griffin that I received today. It looked quite big so I measured it.

It iscoming up as 19". I am measuring from the start of the 'thorowgood button on the side of the pommel to the middle edge of the cantle. Is this correct?

I didn't even think saddles went up to 19" in length? Maybe I'm measuring the wrong way?

If this is right there's no way on earth it's going to fit my pony. If it may fit it may do. It was advertised as 17" It's dirty and 'old looking' though even though advert says 'used once'. Seller has 100% feedback though:confused:
 
i measure from the middle of the front arched bit(i think it is called a pommel) with a straight tape measure back to the middle of the round bit at the back(i think the cantle)

make sure you dont curve the tape with the seat :)
 
i always measure saddles from the middle of the pommel, to the middle of the cantle, keeping tape straight.

i dont know what button your talking about cos i've never had a saddle like that :)
 
is it the same measurement from the stud to the cantle as from the pommel to cantle
because mine was from pommel to cantle is definately right as it is what it says on the label.
hmm .... im going to go down with my tape measure and investigate :p :)
 
is it the same measurement from the stud to the cantle as from the pommel to cantle
because mine was from pommel to cantle is definately right as it is what it says on the label.
hmm .... im going to go down with my tape measure and investigate :p :)

nope, just re-measured everything - saddle is 17" from pommel centre to edge of cantle but is 18" from stud button to centre of cantle
 
Also while I'm at it - I think the back of the saddle looks a bit odd, just the style I think but haven't seen it before.

It's a thorowgood griffin saddle, the bit underneath the cantle on other one's I've seen are round where as this one is different, the panels underneath that make up the gullet arn't one round bit at the back but you can see the invididual panel. Looks like it was made like that.

Is it just the style?

will add pics in a minute
 
It looks like and endurance type saddle with extended panels, supposed to spread the weight more.

To measure seat size measure from middle of the stud to middle of cantle:)
 
newrider.com